Epilog Fusion Pro Series Firmware and Driver Downloads

Epilog Software Suite 2.1.5 (10/25/2019)

• Everything you need to run your Fusion Pro system
• Installs the Epilog Job Manager and the Epilog Laser Dashboard

Versie 2.1.5 Release Notes

• Added a Construction Line tool to assist with artwork placement when using the IRIS™ camera system.
• The corners, midpoints, and center of the selection area will snap to these Construction Lines
• Added Center-Center mode for Fusion Pro engravers
• There is an icon that shows where the red dot on the machine will correspond to in the job
• Requires firmware update to function

Previous Version Release Notes

• Auto Focus improvements
• Fiber optimizations

- For more information on the Job Manager, click here.
- Download Software Suite install and use instructions.

- For information on how to use the new Construction Lines feature, click here.

64-bit (x64)

Let op: Remove previous version of Epilog Job Manager and Epilog Software Suite before installation! (Go to Control Panel > Programs and Features and remove the software.)

Let op: Windows 7/8/10 vereist om de Epilog Job Manager te kunnen gebruiken.

Nu downloaden

32-bit (x86)

Let op: Remove previous version of Epilog Job Manager and Epilog Software Suite before installation! (Go to Control Panel > Programs and Features and remove the software.)

Let op: Windows 7/8/10 vereist om de Epilog Job Manager te kunnen gebruiken.

Nu downloaden

Firmware: 1.0.2.0 (10/25/2019)

Let op: Be sure to update to the latest version of the Epilog Software Suite (see above) before updating your machine's firmware.

INSTALL 1.0.1.0 FIRST
Let op: Firmware release 1.0.2.0 can only be installed onto Fusion machines that have already been updated to 1.0.1.0. Be sure your machine has first been updated to Firmware release 1.0.1.0 (available below).

• Added power compensation for vector processing
• Added Center-Center engraving
• Added Registration (Fiducial) camera functionality
• Improved Jogging control for smoother jogging
• Added laser fire button for laser alignment
• Added enhanced diagnostics

Download Firmware 1.0.2.0

---

Firmware: 1.0.1.0 (09/24/2019)

Let op: Be sure to update to the latest version of the Epilog Software Suite (see above) before updating your machine's firmware.

• Added Dual Source capability
• Improved rotary performance
• Improved Tracing function
• Added Auto Focus capability
• Added DNS and Gateway to Network configuration
• Red Dot button is now red when enabled
• Added screen and log capture
• Added configuration capture/restore

Lees de instructies voor installatie

Download Firmware 1.0.1.0